SeedCode Support Forum

Hello,

I'm having an issue with a sync where a table has no records. The effect is that all syncs end with the error dialogue, which is confusing for users as the sync has in fact worked. Any idea why this is happening and how it can be prevented?

Thanks,

Alec

See the log below:

00:00:00 - 00:01:08 - STARTING STAKEHOLDER PULL

00:00:00 - 00:01:08 - Starting Pull
00:00:00 - 00:01:08 - Starting to Pull "gzh_STAKEHOLDER"
00:00:00 - 00:01:08 - Last Time Zync: ""
00:00:00 - 00:01:08 - FLM is OFF
00:00:00 - 00:01:08 - Starting TO Filter - "gzh_STAKEHOLDER"
00:00:00 - 00:01:08 - Found 0 Records in the filter (Also no records at all in this table)
00:00:00 - 00:01:08 - Looking for record to Delete
00:00:00 - 00:01:08 - no records to delete in "gzm_STAKEHOLDER"
00:00:01 - 00:01:09 - Deletion Complete
00:00:00 - 00:01:09 - Pulling all filtered records
00:00:00 - 00:01:09 - Starting sync on 1 records. (Why is there 1 record to sync in an empty table?)
00:00:00 - 00:01:09 - Sync halted at record # 1 due to error. Incomplete changes were rolled back. (Not surprising, given there are no records).
00:00:00 - 00:01:09 - Done Pulling "gzh_STAKEHOLDER"

00:00:00 - 00:01:09 - Pull Complete

00:00:00 - 00:01:09 - ENDING STAKEHOLDER PULL

Hi Alec,

Thanks for getting in touch. I wasn't able to reproduce this in a fresh, stock copy of GoZync 4.052, so this might be something that was fixed in that release. Follow the instructions to update your files starting here:

http://www.seedcode.com/pmwiki/pmwiki.p ... ionHistory

Then try synching again. Let me know how that goes.

Jeff