tanner's Profile
If you haven't already, navigate to the "Settings" tab in the calendar sidebar and click "Account Settings". Click "Check For Updates". This button should change to "Install Update" and inform you that version 10.24 is available. Click "Install Update".
To update the necessary scripts, begin by downloading the latest version of DayBack here:
You should follow these instructions if you have done the embedded integration or the linking integration and you don't want to perform the integration all over again.
The Changes
Update the following scripts in your current DayBack File (Your file if you have done an embedded integration), but don't delete the script itself. Rather, just replace or add the script steps highlighted in the images below from the new version of DayBack into the corresponding script in your DayBack file. You may get an error when opening both files at the same time. This is expected and you can just say "OK" to those errors before continuing. Here are the scripts and script steps that needs to be updated this way:
"WebViewer Settings" REPLACE the script step "$sc_OptionsResult"
- Screen Shot 2018-02-01 at 4.36.34 PM.png (243.59 KiB) Viewed 9807 times
"Show Repeating Event Options Window" Wrap the script steps from line 18 and 19 in an if statement. Shown as lines 19 and 20 in the image below (SeedCode Complete Users - Please note that this update instruction step is not necessary in if you are updating in SeedCode Complete):
- Screen Shot 2018-02-12 at 2.56.06 PM.png (126.81 KiB) Viewed 9810 times
"Go To Related Record From WebViewer" Add a comment about a new available variable "$eventSourceNumber"
- Screen Shot 2018-02-13 at 2.36.50 PM.png (144.93 KiB) Viewed 9810 times
Finishing Up:
Close the new DayBack file you used to copy the script contents from.
Change the build number recorded in the database. Navigate to "File -> Manage -> Database" then go to the "CalendarInterface" table. Change the "BuildNumberCalc" calculation to read "10.24". Click "OK" to save those changes.
Then please run the "Upon Opening" script in your file. This will ensure all of the new settings load properly and the calendar loads with the correct data.
That's it, enjoy DayBack 10.24.
