Please back up your file before making any changes.

Note: This script update fixes an edge case scenario and is not required for the update to run. Please update the script to keep your code base in sync but this is not a required change.

If you haven't already, navigate to the "Settings" tab in the calendar sidebar and click "Account Settings". Click "Check For Updates". This button should change to "Install Update" and inform you that version 10.27 is available. Click "Install Update".

The Changes

Update the following script in your DayBack file:

"SearchCSS (start)" REPLACE "=" with an ">=" on the exit loop script step as shown in the screenshot below:




Finishing Up:
Change the build number recorded in the database. Navigate to "File -> Manage -> Database" then go to the "CalendarInterface" table. Change the "BuildNumberCalc" calculation to read "10.27". Click "OK" to save those changes.

Then please run the "Upon Opening" script in your file. This will ensure all of the new settings load properly and the calendar loads with the correct data.

That's it, enjoy DayBack 10.27.