Please back up your file before making any changes.
If you haven't already, navigate to the "Settings" tab in the calendar sidebar and click "Account Settings". Click "Check For Updates". This button should change to "Install Update" and inform you that version 10.32 is available. Click "Install Update".
To update the necessary scripts, begin by downloading the latest version of DayBack here:
You should follow these instructions if you have done the embedded integration or the linking integration and you don't want to perform the integration all over again.
The Changes
Update the following script in your current DayBack File (Your file if you have done an embedded integration), but don't delete the script itself. Rather, use the "Select All" command to select and delete the entire contents of each script, then copy/paste the updated contents of the script from the new version of DayBack into the corresponding script in your DayBack file. You may get an error when opening both files at the same time. This is expected and you can just say "OK" to those errors before continuing. Here is the script that needs to be updated this way:
"Substitute Character Disctionary"
The following scripts will need individual script steps added to them. As in the previous step you can copy the script steps from the new DayBack file you downloaded. Then paste them into your script. For these you will not need to delete any existing script steps, just add the new ones as pictured below.
"Submit Event From WebViewer"
The script step "Set Variable $sc_PackageData" has been updated. You can copy the contents of the script step from the newly downloaded file and replace the contents of that step in your file. Or just make sure it looks like the screenshot below.
Finishing Up:
Close the new DayBack file you used to copy the script contents from.
Change the build number recorded in the database. Navigate to "File -> Manage -> Database" then go to the "CalendarInterface" table. Change the "BuildNumberCalc" calculation to read "10.32". Click "OK" to save those changes.
Then please run the "Upon Opening" script in your file. This will ensure all of the new settings load properly and the calendar loads with the correct data.
That's it, enjoy DayBack 10.32.
Updating To DayBack 10.32
1 post
• Page 1 of 1
1 post
• Page 1 of 1
Return to DayBack Calendar for FileMaker
Who is online
Users browsing this forum: No registered users and 1 guest