Updating To DayBack 10.47

Notes on our latest calendar for FileMaker 13,: DayBack
SeedCode Staff
SeedCode Staff
Posts: 98
Joined: Mon Aug 13, 2012 7:43 am
PostPosted: Fri Jan 25, 2019 12:29 pm
Please back up your file before making any changes.

If you haven't already, navigate to the "Settings" tab in the calendar sidebar and click "Account Settings". Click "Check For Updates". This button should change to "Install Update" and inform you that version 10.47 is available. Click "Install Update".

The Changes

There have been some significant CSS changes in the redesign of the sidebar header. For these changes to render correctly some existing CSS rules will need to be removed from your current theme file. Please navigate to the "Webviewer: Under The Hood" layout.

If you have not made any theme modifications click the "Restore Built-In Themes" button to update the theme files to the latest version.

If you are not sure, or have made theme file changes then click the edit icon to the right of your currently active theme file. and follow the instructions below.

Screen Shot 2019-01-25 at 12.14.08 PM.png
Edit Theme
Screen Shot 2019-01-25 at 12.14.08 PM.png (109.77 KiB) Viewed 7677 times


Once the editor is up locate the section labeled "Tab panel in sidebar" and delete that section of CSS as shown highlighted below.

Screen Shot 2019-01-25 at 9.49.16 AM.png
Remove CSS
Screen Shot 2019-01-25 at 9.49.16 AM.png (346.28 KiB) Viewed 7677 times


Once those CSS rules are deleted click "Save Changes & Apply" to make that change permanent.

If you would like to revert to the previous sidebar header design you can add some new CSS rules to your theme file. That CSS can be found on a blog post here: https://www.seedcode.com/preview-new-sidebar-header-for-dayback/.

If you had made CSS changes prior to updating you can re-apply those changes once adding the CSS referenced above to revert to the previous design. If you have trouble with that please reach out.

Finishing Up:
Close the new DayBack file you used to copy the script contents from.
Change the build number recorded in the database. Navigate to "File -> Manage -> Database" then go to the "CalendarInterface" table. Change the "BuildNumberCalc" calculation to read "10.47". Click "OK" to save those changes.

Then please run the "Upon Opening" script in your file. This will ensure all of the new settings load properly and the calendar loads with the correct data.

That's it, enjoy DayBack 10.47.

Return to DayBack Calendar for FileMaker

Who is online

Users browsing this forum: No registered users and 2 guests

cron
(855) SEEDCODE
[email protected]
Follow us: